|
|
This is only a preview of the paper
Click here to register and get the full text.
Existing members click here to login
|
|
|
Here is your guide to building an ELECTRIC TURBO/SUPERCHARGER! Please be sure to thoroughly read these instructions before attempting the installation. These instructions will teach you how to build an inline electric supercharger that will fit any 3" or 4" intake, whether it is aftermarket or bone stock with little or no modification. Here are the directions and parts list for the version being sold on ebay for up to $100.00. Parts list: 1-attwood 3" or 4" Turbo IN-LINE Blower (exact size will depend on the size of your intake tubing, be sure to measure just to be sure) 1- 3" or 4" piece of soft pipe, you may or may not need this depending on your intake 1- SPST Momentary Pushbutton Switch 1- Roll of electrical tape 1- Metal Bracket 1- 25ft Roll of 12-Gauge wire Please note that it is recommended that you use this with an aftermarket intake for best results. Also if used with a stock intake you may have to modify either the intake system or modify the in-line blower, this is an option, but not recommended. For use on aftermarket intakes, simply insert the blower in the intake right before the air filter. Please make sure the airflow arrow is pointing towards the engine. If you are installing in a factory intake you may have to modify the intake or the blower. Once again, please take note that I do not recommend modifying the intake. Once you get the fan installed reconnect the air filter. Next connect a piece of the 12 gauge wire to the ground terminal of the battery, and then run the wire neatly to the ground wire (black) on the fan. Please be sure to note that the keyword in the previous sentence is NEAT, you don’t want it coming loose and getting in the way of moving parts, plus you want it to look good don’t you!?!?!?!
Approximate Word count = 1181
Approximate Pages = 4.7
(250 words per page double spaced)
|
|
|
|
|
|